Manufacturing

Gravity Die Casting vs High Pressure Die Casting: Which Is Right for Your Part?

▶ HPDC produces cycle times of 15 to 45 seconds versus GDC’s 2 to 5 minutes, making HPDC the choice […]

Introduction: Why Location Matters in Die Casting Supply Chains If a Tier-1 supplier from Chakan MIDC requires a large quantity

► Plasma Aluminium Diecasting provides first-article samples within 6 to 10 weeks of drawing freeze and tooling PO — covering

► Automotive and two-wheeler manufacturing is the largest end-use sector for aluminium die casting in Pune, accounting for approximately 60

► LPDC fills the die from below using controlled gas pressure (0.5 to 1.0 bar) on the melt surface, producing

► Dimensional inspection of aluminium die cast parts should cover all print-critical dimensions using calibrated gauges or CMM, with Cpk

► Squeeze casting applies high pressure (70 to 140 MPa) to liquid or semi-solid aluminium metal in a die cavity,

► Aluminium’s density is 2.71 g/cm3 compared to cast iron at 7.2 g/cm3 — a die cast aluminium part weighs

▶ Moshi is located 12 to 18 km from Chakan MIDC, placing buyers in the Moshi zone within 30 to